Plane Old Wood
 
This is my first woodworking project. I built it to enter in a student competition. I placed 4th at Regional’s and 6th at International’s with students from around the world. My Inspiration for this project come from an article from issue #176 of Fine Woodworking magazine.
Picture
My choice of subject for my bench top work bench was because I wanted something useful that I knew I would use often. My project is basically a miniature work bench. Its purpose is to bring the work your doing up higher for easier accessibility and comfort. I used hard maple for my project because it is traditionally used for workbenches. It is a good hardwood and very strong. Walnut is also a good hardwood and accented the hard maple well.

I used mortise and tenon joints to attach most of my project because they are very strong and durable. I used box joints for the breadboard end to allow for expansion and contraction as the moisture of the wood changes. I used butt joints reinforced with biscuits for alignment and strength. I sanded and scrapped it with cabinet scrappers. I used a natural oil finish because it is best suited for a work bench because it protects the wood while allowing to recoat as wood is worn.

See the my viewer project posted on The Wood Whisperer

http://thewoodwhisperer.com/jordans-benchtop-workbench/

My Build Order and Tools Used

Steps to complete project
 1. I started by selecting the wood I thought would best suit my project. I chose hard maple and walnut because I knew they would access each other well. 
2. I cut several of the bigger pieces down so I could mill them. 
3. I ran them all through the jointer and planner till they were the correct widths and heights. 
 4. I then took my leg and feet boards and cut their mortises with a hollow chisel mortis. 
 5. I cut the tenon on the table saw with a tenoning jig.    
 6. I used a chisel to clean up the mortises and a block shoulder plane to fit the tenon.  
 7. I glued two hard maple and one walnut board together to make the surface of my table. I also cut biscuit holes in them to make them stronger.  
 8. I cut the box joins in the breadboard ends on the table saw.
9. I attached the side vice.
 10. I attached the top to the base.
 11. I used a brace and bit to drill the dog holes in the vice chop and the table top.
 12. I sanded and finished the bench with Boiled Linseed Oil

Tools used
Table saw.
Hollow chisel mortise 
Jointer
Planer Chisel
Chop saw